2000 Toyota Tundra Drive Cycle

The grille was updated in 2002 for the 2003 model year along with a new Stepside bed available on Access Cab models.

2000 toyota tundra drive cycle. ToyotaLexus use a series of diferent drive traces for each system monitor. The blower motor is located directly below the passanger glove box on the right. Ive only drove in D2 with the RPM at around 3000 once.

In this case you must continue the drive cycles until the malfunction shows up. Most of the weight of the vehicle is absorbed by the power steering system making it feel much lighter than it really is. Its a round flat plate with 2 small screws holding it in place.

Scootn2nature Apr 19 2013 2. Toyota has various OBD2 readiness monitors for emissions testing and by conducting a Toyota Drive cycle you can activate and ready the Toyota ODBII sensors. Drive at a steady speed between 40 and 70 MPH for 10 minutes.

Altitude is below 7801 feet 2400 m. The diagnostic codes that are required by law on all OBDII systems are generic in the sense that all vehicle manufacturers use the same common code list and the same 16-pin diagnostic connector. I have a 2000 Toyota Tundra V6 Base Model that wont pass smog in California I have replaced the Up and Downstream O2 Sensors but still get the notice on my ODB2 Scanner that the Catalyst and the Evaporative systems have yet to report any data and that is what is causing the SMOG check to fail.

You must park the vehicle in a heated garage above 40 F for 12 hours with the key off and fuel tank at 12 to run the evap monitor. Follow them as carefully as possible. The following Toyota Tundra OBD II Drive Cycle should set all the required emission monitors.

Im sure some more knowledgeable people will chime in. 1996 to 2002 Toyota OBD II Monitor Readiness Drive Patterns. According to customer reports the Tundra can last up to 1000000 miles on the road.