2004 Toyota Tundra Door Panel Removal

Tools youll need are the same tools that youll need to just remove the door panel.

2004 toyota tundra door panel removal. Disconnect and remove power lockwindow unit usually pries up from one end rear of car and slides out. Once you pull from the bottom you need to lift UP so it comes off of the lip. Fear not they are cheap to replace at your local Toyota dealer.

From time to time you may break one. Door panels need to be removed to access the inside components of the door li. There are plastic clips holding the door panel in place around the outside edges of the panel.

The door is hanging on by the top sill. Take a long screw drive you can buy a door panel removal tool but all it is flat piece of metal with a slot cut into the end to line up with the panel plastic hold tabs. Do not let the panel go since it is still connected in other places.

The screws may be located behind plugs that you remove with small flat screw driver. 2004 Toyota Tundra 14999. Thats a flat blade screwdriver both the regular and small size Phillips screwdriver and a door panel clip tool or a putty knife.

Pull out the sliding cup holder from the center dash panel. Locate screw holes for door handle and other areas maybe and remove. Great job on explaining the door panel removal.

By continuing to use this site you consent to the use of cookies on your device as described in our cookie policy unless you have disabled them. With the screw drive gently pry on one corner and until it pops now you can see the other tabs and gently pop those out. 2004 - 2006 Toyota Tundra.