2006 Toyota Tundra Transmission Fluid Fill

Dump the contents of the pan in the milk jug you marked earlier.

2006 toyota tundra transmission fluid fill. 2006 Toyata Tundra-adding transmission fluid. BEFORE TRANSMISSION FILL. This transmission requires Toyota Genuine ATF WS transmission fluid.

Place one end in the fill hole and put a funnel on the end in the engine compartment and fill that way. If you should remove the overflow plug now have a pan ready as fluid will spill. The fluid wont be under any significant pressure so a hose clamp isnt necessary.

If the transmission fluid level on your Tundra is low you need to add fluid through the dipstick tube. Connect the vinyl tubing to the transmission cooler line as shown in the pics. How To Check Transmission Fluid In 2006 Toyota Tundra.

To refill you take the 22 or 24 mm bolt out on the back of the trans near where the driveshaft goes in useing a pump fill like a rear end differential. Maintain the vehicle in a horizontal position while adjusting fluid level. Use the refill plug to fill in fluids till it overflows from the overflow plug and reinstall the overflow plug and refillplug.

Run engine to operating temperature and remove the overflow plug. I show you how i changed all the transmission fluid in my 2007 Toyota Tundra 47. It should have a minimal amount of fluid in it about 3 cc.

Well there are a myriad of ways to approach this. Remove Dipstick - Access point for transmission fluid. You might need to expand the end of the tubing with a pair of needle nose pliers so it will fit over the transmission line.