2001 Toyota Tundra Ignition Switch Removal

Turn the lock cylinder into the Accessory position with the key and insert a small screwdriver into the hole at the bottom of the ignition switch casting.

2001 toyota tundra ignition switch removal. This is the 4th time in the last 2 weeks this has occured so where do I. Put a piece of tape over it as a silencer that way you dont accidentally cut the wrong wire or disable a key function. Replacing ignition switch after it got me stranded after a small ice storm we had.

Genuine Unistrut P2750-EG 4 Wheel Light Duty Trolley Assembly for use with P1000 P1001 P5000 P5001 P5500 P5501 and All 1-58 or Taller Strut Channel. Problems in getting anyone of my keys to turn the ignition. Disconnect battery ground cable 14301.

So watch and see how Allen helpe. Rotate ignition switch lock cylinder 11582 to the RUN position. Remove lower instrument panel steering column cover 04459.

When I got ready to leave the Fed Ex place I had parked at the key would not turn in the ignition. Remove the two screws retaining ignition switch 11572. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing.

Make sure both the lock cylinder and column lock are in the ACC position. USUALLY though the problem is caused by pressure of the steering wheel lock bar on the cylinder. 2006 toyota tundra the ignition switch is sticking and at present is stuck thus not allowing the truck to start.

Turn the steering wheel to expose and remove Philips screws on either side to allow removal of lower steering column cover. 2001 Ignition switch assembly. Secure the switch with its screws.